Andritz MC Series - Delta Pompen B.V.

Delta Pompen B.V.

Go to content

Main menu:

Andritz MC Medium Consistency Pump

Pump description:
The MC pump has been developed as a basis for the paper industry, such as dust pump, white water pump and pulper pump, for pumping a higher consistency to even 16%.
The pump is equipped with a fully open impeller, mounted between two wear plates to protect the pump housing. The bearing seat/ pump shaft construction is developed to absorb large forces. The material composition of this pump is made of wear-resistant duplex material. The pump is fitted with a screw that transports the high consistency at the front.

MC Pump: Pump with separate bearing seat, spacer coupling and IEC motor (mounted on same base plate.)

Key features:
Flow rates up to:             13.000 admt/d
Heads up to:                     190 m
Casing pressure up to:  16 Bar
Temperature:                 -20ºC to +140ºC
Consistency up to:          16%

The impeller and wear plates are standard made in duplex (1.4460). The pump housing is made in cast iron, as well as in duplex 1.4460. For highly abrasive liquids we have the ability to perform the entire pump in superduplex 1.4517 material. We can even cure the latter material for an even higher wear resistance.

A fully open impeller, with three or six blades. The impeller is placed between two stationary wear plates to protect the pump housing.

Shaft Seal:
The pump shaft seal is made with a single mechanical seal following DIN24960 or double mechanical seal (tandem or back-to-back setup). The composition of materials are able to put together by customer specifications. Other options like a expeller seal is also possible.

Standard B3 IEC engine can be supplied from any brand. ATEX engines are also possible.

You can find the MC pumps in paper mills as a high consistency dust pump.


MC Series Brochure

Copyright © All rights reserved.
Delta Pompen B.V.
Rigaweg 17
9723 TE Groningen (NL)
Back to content | Back to main menu