A horizontal single closed impeller end suction pump, fitted with an oil-lubricated bearing seat. The pump has been developed according to the process design and features a back pull out unit, for maintenance with the pump housing remaining in the pipes. The pump is built on a foundation frame and equipped with an IEC motor, spacer coupling and coupling guard.
Flow rates up to: 450m³/hr
Heads up to: 150 m
Casing pressure up to: 16 Bar
Temperature: -10ºC to +140ºC
According to : Process design ISO 2858 / EN 22858 en ISO 5199 / EN 25199
Various material designs, including cast iron, bronze, stainless steel.
Closed impeller, with multiple blades and discharge holes.
The pump shaft seal is made with a single mechanical seal following DIN24960 or double mechanical seal (tandem or back-to-back setup).The composition of materials are able to put together by customer specifications.
Standard B3 IEC engine can be supplied from any brand. ATEX engines are also possible.
These pumps are used where clean to slightly contaminated liquids needed to be pumped.