The ACP pump has been developed as a basis for the paper industry, such as dust pump, white water pump and pulper pump. The pump is equipped with a fully open impeller mounted between two wear plates, to protect the pump housing. The bearing seat / pump shaft construction is highly developed to absorb large forces. The material of this pump is made of wear-resistant duplex material.
ACP Pump: Pump with separate bearing seat, spacer coupling and IEC motor (mounted on same base plate.)
Flow rates up to: 6.000 m³/hr
Heads up to: 160 m
Casing pressure up to: 25 Bar
Temperature: -20ºC to +200ºC
According to: Process design
The impeller and wear plates are standard made in duplex (1.4460). The pump housing is made in cast iron as well as in duplex 1.4460. For highly abrasive liquids we have the ability to perform the entire pump in superduplex 1.4517 material. We can even cure the latter material for an even higher wear resistance.
A fully open impeller, with three or six blades.The impeller is placed between two stationary wear plates to protect the pump housing.
The pump shaft seal is made with a single mechanical seal following DIN24960 or double mechanical seal (tandem or back-to-back setup).The composition of materials are able to put together by customer specifications.Other options like a expeller seal is also possible.
Standard B3 IEC engine can be supplied from any brand. ATEX engines are also possible.
You can find the pumps in many applications where clean to heavily contaminated liquids must be pumped. Especially in the paper mills, this pump is widely used, but also for seawater transport and applications in the general industry.